Tire Pressure Sensor: Service and Repair

Operation number: 38641-2

Pressure sensor tire

Note! Some variation in the illustrations may occur, but the essential information is always correct.

Removal

Note! Removal steps in this procedure may contain installation details.

Remove the wheel.






Caution! Do not use tools within the marked area.

Caution! Always start outside the marked area and continue in the direction from the valve.

Caution! Release the tire bead from the wheel rim diagonally opposite to the valve.

Tighten the pressure sensor. Refer to: Tightening torque [1][2]Specifications

Installation

To install, reverse the removal procedure

Install the wheel. Refer to: Wheels Service and Repair

After replacing sensors, the control module does not need programming. The control module contacts the sensor itself after a few minutes driving. LF initiator can be used.