Cabin Temperature Sensor / Switch: Service and Repair

Temperature sensor passenger compartment

Note! The illustrations in this service information are used for different model years and/or models. Some variation may occur. However, the essential information in the illustrations is always correct.

Preparatory work

Component overview






Removing components




Use a weatherstrip tool and remove the panel inside the center console. It is secured with 4 hidden clips.




Remove the end cover on the left-hand side. Use a weatherstrip tool and start at the rear edge.
Remove the 3 screws and the clip for the driver's side soundproofing panel. Leave the soundproofing panel hanging from the cable harness.

Removal

Removing the blower fan motor passenger compartment temperature sensor




Disconnect the connector.
Press in the catches. Lift straight up.

Installation

Installing the blower fan motor passenger compartment temperature sensor

Install:
- the blower fan with the passenger compartment temperature sensor
- the connector
- the driver's side soundproofing panel using the 3 screws and the clip
- the end cover
- the panel inside the center console.