Control Module HVAC: Service and Repair

Climate control module (CCM)

Note! The illustrations in this service information are used for different model years and/or models. Some variation may occur. However, the essential information is always correct.

Preparatory work

Important information




The unit is a complete control module that has many different functions in addition to controlling the climate functions.

Removal

Removing center console
Ignition off.




Remove the panel inside the center console. It is secured with 4 hidden clips.




Remove the radio panel. It is secured with 2 hidden hooks.

Hint: Insert a small screwdriver and push the hooks away, 1 per side.




Remove the infotainment control module (ICM). It is secured with 2 hidden clips.

Hint: Grip the infotainment control module (ICM) with both hands. Push the control module straight out of the center console.

Remove:
- the 2 connectors from the infotainment control module (ICM)
- the connector from the center console.





Remove:
- the panel. See: Power socket 12V Service and Repair
- the 4 screws.
Unclip the gear selector lever boot.
Lift the center console up / out.

Removing the climate control module (CCM)





Remove:
- the 8 screws.




- the 4 screws
- the climate control module (CCM).

Installation

Installing the climate control module (CCM)

Caution! Tighten the screws carefully. There is a risk of cracks forming.

Install:
- the climate control module (CCM) on the front section of the center console
- the 4 x screws. Tighten. See: Tightening torque, B5254T7 [1][2]Body and Frame
- the rear section of the center console
- the 8 screws. Tighten. See: Tightening torque, B5254T7 [1][2]Body and Frame.

Installing center console

Install:
- the gear selector lever boot
- the center console
- the 4 screws. Tighten
- the panel. See: Power socket 12V Service and Repair
- the connector for the center console
- the 2 connectors for the infotainment control module (ICM)
- the infotainment control module (ICM). It is secured with 2 hidden clips
- the radio panel
- the panel inside the center console. It is secured with 4 hidden clips.

Finishing

Ordering software
Order software.






Programming customer parameters and adjusting damper motors
Reprogram the customer programmed data
Carry out self-adjustment of the damper motor end positions. This is carried out in VIDA Vehicle communication.
Test drive the vehicle. Check that the engine and climate control system are functioning.