Fuel System Pressure Release

Fuel system pressure release

Note! The illustrations in this service information are used for different model years and/or models. Some variation may occur. However, the essential information in the illustrations is always correct.

Pressure reduction






Warning! The fuel system remains under pressure for a long time after the ignition has been switched off. The fuel pressure must be released before beginning any repairs. Failure to follow the instructions can result in personal injury.

Removal

Removing the fuse for the fuel pump (FP)
Remove the fuse for the fuel pump (FP).
Start the engine and allow to idle until it stops.
Turn the engine using the starter motor for approximately 5 seconds until the pressure in the fuel rail has been reduced.

Installation

Installing the fuse for the fuel pump (FP)
Install the fuse for the fuel pump (FP).