Control Lock Engine Hood

Control lock engine hood

Note! The illustrations in this service information are used for different model years and/or models. Some variation may occur. However, the essential information in the illustrations is always correct.

Removal

Removing the hood lock control




Fold back the insulation panel by the hood lock control.

Remove:
- the 2 nuts
- the mechanical cable from the control
- control.

Installation

Note! For tightening torques, see: Tightening torque, B5254T7 [1][2]Body and Frame.

Installing the hood lock control

Install:
- the control
- the cable
- 2 M6 nuts. Tighten.
Ensure that the insulation panel is in the correct position.
Check the function of the control.