Checking Radio Mute, Accessory

Checking radio mute, accessory

Fault-tracing information
Fault causes which will prevent the radio mute function working:
- Fault or loose connections in the cable between the telephone and the handsfree box
- Fault in the connection between the handsfree box and the accessory electronic module (AEM).

Continue - Checking the components and wiring

-------------------------------------------------

Checking the components and wiring

Hint: Check that no diagnostic trouble codes (DTCs) have been stored in the accessory electronic module (AEM) or in the MOST network before carrying out this fault-tracing.




- Ignition off
- Disconnect the connectors for the handsfree box and accessory electronic module (AEM).
Check that the telephone connections on the phone and in the holder are clean. Check that the connector guards are in not place.
Check the connectors. Check for loose connections. Check for contact resistance and oxidation. Check the female and male sections of the connectors. The terminals must not be damaged or pressed in.
Check the cable between the phone and handsfree box. Check for an open-circuit.
Check the cable between the handsfree box and the accessory electronic module (AEM). Check for an open-circuit.

Other information
- Signal specification Signal Specification, Handsfree Accessories
- Checking wiring and terminals Checking Wiring and Terminals









Continue - Verification

-------------------------------------------------

Verification




Verification

Hint: After carrying out the repair, check that the fault has been remedied.




- Ignition on.
Check that radio mute is functioning.

Is the function OK?

Yes - VERIFIED

No - VERIFICATION FAILED

------------------------

VERIFIED - FAULT FOUND

VERIFICATION FAILED - Fault-tracing information

-------------------------------------------------

Fault-tracing information




Information

Fault-tracing information
The fault should have been detected and remedied. As this is not the case fault-tracing has failed.
Exit fault-tracing for this diagnostic trouble code (DTC) or make another attempt.

Do you want to exit fault-tracing?

Yes - Exit fault-tracing

No - Attempt New Test

------------------------

Attempt New Test - Fault-tracing information

-------------------------------------------------