Calibration Fault

Calibration fault

Replacing the component
The steering wheel module (SWM) has registered an internal fault.
Turn the steering wheel more than 90 degrees in order to perform a new calibration.
If the fault is intermittent, it has been registered previously but is no longer present. Intermittent faults can be caused by interference at start up of the steering wheel module (SWM) or may be a different type of fault which occurs on different occasions. The fault is evaluated depending on how it occurs. Replace the steering wheel module (SWM) if the fault recurs.
Replace the steering wheel module (SWM) in the event of a permanent fault.

Remedy as necessary.





Continue - Fault-tracing information

-------------------------------------------------

Fault-tracing information




Information

Fault-tracing information
In case of this defect, troubleshooting is not followed by verification.
The information can be displayed again or the fault-tracing for this fault can be interrupted.

Do you want to view the information again?

Yes - Attempt New Test

No - FAULT FOUND

------------------------

Attempt New Test - Replacing the component

FAULT FOUND - DONE

-------------------------------------------------