Current Too Low

Current too low

Replacing the component
The steering wheel module (SWM) has registered that the current through the LEDs for the steering wheel angle sensor is too low.
The steering wheel angle sensor is integrated in the steering wheel module (SWM) and cannot be replaced as a separate unit.
If the fault is intermittent, it has been registered previously but is no longer present. Intermittent faults may be due to interference at start up of the control module or may be a different type of fault which occurs on different occasions. The fault is evaluated depending on how it occurs. Replace the steering wheel module (SWM) if the fault recurs.
Replace the steering wheel module (SWM) in the event of a permanent fault:
Remedy as necessary.

Other information
- Steering wheel control module Service and Repair





Continue - Fault-tracing information

-------------------------------------------------

Fault-tracing information




Information

Fault-tracing information
In case of this defect, troubleshooting is not followed by verification.
The information can be displayed again or the fault-tracing for this fault can be interrupted.

Do you want to view the information again?

Yes - Attempt New Test

No - FAULT FOUND

------------------------

Attempt New Test - Replacing the component

FAULT FOUND - DONE

-------------------------------------------------