Initiation Fault

Initiation fault

Checking the control

Hint: The diagnostic trouble code (DTC) is stored if the steering wheel module (SWM) has registered that the button for the cruise control at start up has been depressed for more than 60 seconds.

Check that the button/switch does not stick in the activated position.

Hint: Read off the relevant button/switch and check the function.

Remedy as necessary.

Other information:
- Keypad, steering wheel Service and Repair









Continue - Verification

-------------------------------------------------

Verification




Verification

Hint: After carrying out the repair, check that the fault has been remedied.








- Ignition off
- Reconnect the connectors, components, etc.
- Ignition on.
Check that the function is correct.





Is the function correct?

Yes - VERIFIED

No - VERIFICATION FAILED

------------------------

VERIFIED - FAULT FOUND

VERIFICATION FAILED - Fault-tracing information

-------------------------------------------------

Fault-tracing information




Information

Fault-tracing information
The fault should have been detected and remedied. As this is not the case fault-tracing has failed.
Exit fault-tracing for this diagnostic trouble code (DTC) or make another attempt.

Do you want to exit fault-tracing?

Yes - Exit fault-tracing

No - Attempt New Test

------------------------

FAULT-TRACING FAILED - No Fault Found

Attempt New Test - Checking the control

-------------------------------------------------