Signal Missing

Signal missing

Checking components and wiring








- Switch off the ignition. Wait 10 seconds
- Disconnect the 10-pin connector from the occupant weight sensor (OWS)
- Disconnect the 20-pin connector located under the driver's seat
- Disconnect the connectors from the supplemental restraint system module (SRS).

Caution! Do not touch the terminal pins in the supplemental restraint system module (SRS) and the occupant weight sensor (OWS). There is a risk of static discharge. This could damage the supplemental restraint system module (SRS) and the occupant weight sensor (OWS).

Check the 20-pin connector and the connectors for the occupant weight sensor (OWS) and the supplemental restraint system module (SRS). Check for damage to pins and terminals in the connectors. Check for contact resistance in the connectors.
Remedy as necessary.
Connect the 20-pin connector. Check the CAN cable between the supplemental restraint system module (SRS) and the 10-pin connector for the occupant weight sensor (OWS). Check for an open-circuit.
Check the cable between:
- Supplemental restraint system module (SRS) terminal #A51 and occupant weight sensor (OWS) 10-pin connector terminal #1
- Supplemental restraint system module (SRS) terminal #A52 and occupant weight sensor (OWS) 10-pin connector terminal #10.
Remedy as necessary.
Replace the pressure sensor and the occupant weight sensor module (OWS) if no fault is detected. The pressure sensor and occupant weight sensor (OWS) module are included in the occupant weight sensor (OWS) system.

Note! After replacing the pressure sensor and the occupant weight sensor (OWS) module in the occupant weight sensor (OWS) system, calibration of the occupant weight sensor (OWS) must be carried out.

Other information
- Connecting the breakout box Connecting the Breakout Box, Supplemental Restraint System Module (SRS)
- Signal specification, supplemental restraint system module (SRS): Signal specification Signal Specification
- Signal specification, occupant weight sensor (OWS): Signal specification Signal Specification, Occupant Weight Sensor (OWS)
- For further information about cable routing and terminals, see the wiring diagram
- To access or replace the supplemental restraint system module (SRS) and the connectors. See: Air bag supplemental restraint system Service and Repair
- To access or replace the occupant weight sensor (OWS) and the connectors, see: Front passenger weight sensor Removal and Replacement
- Calibrating the occupant weight sensor (OWS) Testing and Inspection
- For information about the repair of SRS wiring, see: Wiring harness supplemental restraint system (SRS) Wiring Harness Supplemental Restraint System (SRS)
- Checking wiring and terminals Checking Wiring and Terminals





Continue - Verification

-------------------------------------------------

Verification




Verification

Hint: After carrying out the repair check that the fault has been remedied.




- Switch off the ignition. Wait 10 seconds
- Disconnect the battery negative lead
- Reinstall the connectors, components etc.
- Ignition on
- Connect the battery negative lead. Wait 10 seconds.

Warning! There must not be anyone inside the passenger compartment when the battery is connected.

Read diagnostic trouble codes by clicking the VCT2000 symbol.
If the fault is intermittent, the fault has been remedied.





Is the fault intermittent?

Yes - VERIFIED

No - VERIFICATION FAILED

------------------------

VERIFIED - FAULT FOUND

VERIFICATION FAILED - Fault-tracing information

-------------------------------------------------

Fault-tracing information

FAULT-TRACING FAILED - No Fault Found

Attempt New Test - Checking components and wiring

-------------------------------------------------