Wrong Measurement Range

Wrong measurement range

Replacing the component




- Switch off the ignition. Wait 10 seconds.
Replace the pressure sensor in the left-hand door.

Other information
- Collision sensor, side Collision Sensor, Side

Continue - Verification

-------------------------------------------------

Verification




Verification

Hint: After carrying out the repair check that the fault has been remedied.




- Switch off the ignition. Wait 10 seconds
- Disconnect the battery negative lead
- Reinstall the connectors, components etc.
- Ignition on
- Connect the battery negative lead. Wait 10 seconds.

Warning! There must not be anyone inside the passenger compartment when the battery is connected.

Read diagnostic trouble codes by clicking the VCT2000 symbol.
If the fault is intermittent, the fault has been remedied.





Is the fault intermittent?

Yes - VERIFIED

No - VERIFICATION FAILED

------------------------

VERIFIED - FAULT FOUND

VERIFICATION FAILED - Fault-tracing information

-------------------------------------------------

Fault-tracing information

FAULT-TRACING FAILED - No Fault Found

Attempt New Test - Replacing the component

-------------------------------------------------