Configuration Fault

Configuration fault

Checking the component








- Switch off the ignition. Wait 10 seconds
- Disconnect the connector from the right-hand inflatable curtain
- Disconnect the connectors from the supplemental restraint system module (SRS).

Warning! Under no circumstances use an ohmmeter or other live measuring instrument to take readings on a disconnected non-deployed seat belt tensioner. The seat belt tensioner could deploy!

Caution! Do not touch the terminal pins in the supplemental restraint system module (SRS). There is a risk of static discharge. This could damage the supplemental restraint system module (SRS).

Check the connectors for the inflatable curtain and the supplemental restraint system module (SRS). Check for damage to pins and terminals in the connectors. Also check the wiring.
Remedy as necessary.
Check that the correct supplemental restraint system module (SRS) is installed in the car.
- Connect the connector to the right-hand inflatable curtain
- Connect the connectors for the supplemental restraint system module (SRS)
- Switch on the ignition. Wait 10 seconds
- Read off by clicking the VCT2000 symbol.
If no fault is found, replace the control module.

Other information
- Signal specification Signal Specification
- To access/replace collision curtain and connectors:
Inflatable curtain Inflatable Curtain
- For further information about cable routing and terminals, see the wiring diagram
- To access or replace the supplemental restraint system module (SRS) and the connectors. See: Air bag supplemental restraint system Service and Repair
- Checking wiring and terminals Checking Wiring and Terminals





Continue - Verification

-------------------------------------------------

Verification




Verification

Hint: After carrying out the repair check that the fault has been remedied.




- Switch off the ignition. Wait 10 seconds
- Disconnect the battery negative lead
- Reinstall the connectors, components etc.
- Ignition on
- Connect the battery negative lead. Wait 10 seconds.

Warning! There must not be anyone inside the passenger compartment when the battery is connected.

Read diagnostic trouble codes by clicking the VCT2000 symbol.
If the fault is intermittent, the fault has been remedied.





Is the fault intermittent?

Yes - VERIFIED

No - VERIFICATION FAILED

------------------------

VERIFIED - FAULT FOUND

VERIFICATION FAILED - Fault-tracing information

-------------------------------------------------

Fault-tracing information

FAULT-TRACING FAILED - No Fault Found

Attempt New Test - Checking the component

-------------------------------------------------