Diagnostic Trouble Code (DTC) Information

Diagnostic trouble code (DTC) information SRS-002D

Condition




The supplemental restraint system module (SRS) checks the signal from the driver's adaptive seatbelt force limiter.
The diagnostic trouble code (DTC) is stored if the resistance in the ignition cable is between 1-6 ohms for longer than 2.5 seconds.
The diagnostic trouble code (DTC) can only be diagnosed when the ignition is switched on (12 V). In other words, the diagnostic trouble code (DTC) can only be diagnosed when the ignition is switched from position 0 to positions I, II or III.

Hint: The adaptive seat belt force limiter is installed in the same unit as the seat belt tensioner. To replace the adaptive seat belt force limiter, replace the seat belt tensioner.

Substitute value
- None.

Possible source
- If the supplemental restraint system module (SRS) identifies that a driver's adaptive seat belt force limiter is installed, despite the control module being programmed that one is not installed.

Fault symptom[s]
- General warning lamp lit
- SRS warning message displayed.