Diagnostic Trouble Code (DTC) Information

Diagnostic trouble code (DTC) information PSR-E003

Condition
The control module compares its configuration ID with the signal configuration transmitted on the control area network (CAN) by the central electronic module (CEM). If the configuration IDs do not correspond the fault code is stored. The diagnostic trouble code (DTC) is also stored if the communication between the control module and the central electronic module (CEM) is interrupted.

Note! In the event of an open-circuit in both the control area network (CAN) cables, it is not possible to communicate with the control module. Therefore it will only be possible to read off the fault if it is intermittent. When the diagnostic trouble code (DTC) is stored, the control module responds to the diagnostic commands.





Substitute value
None.

Possible source
Incorrect configuration ID (the control module is not intended for this vehicle, for example it is a used control module with different software/hardware).
Open-circuit in the CAN cables between the control module and the Central Electronic Module (CEM).

Fault symptom[s]
Cannot be operated by remote control
Automatic adjustment of power seat/outer mirror does not work
Degenerated seat function
Memory button does not work