Initializing the Front Seat Position

Initializing the front seat position

Initializing the front seat position
If a front seat loses information about its position a diagnostic trouble code (DTC) is stored and the seat must be initialized.
The seat position must be reinitialized to erase the diagnostic trouble code (DTC).

Select the desired alternative:
1. Initializing seat module, left (PSL).
2. Initializing seat module, right (PSR).
3. Exit.

Select required alternative.

1 - Initializing seat module, left (PSL)

2 - Initializing seat module, right (PSR)

3 - DONE

-------------------------------------------------

Initializing seat module, left (PSL)

- Ignition on.
- Check that nothing prevents the seat's movement during initialization.
- At initiation of motor 1, the seat must be at least 5 cm from the rear end-position.
- At initiation of motor 2, the backrest must be at least 10 cm from the front end-position.
Initiation takes place in two steps. One for initiation of the seats' motor fore-aft (M1) and one for the seat's motor in the backrest (M2).
Initialize the seat by clicking on the VCT2000 symbol.
Verify initialization by checking that the diagnostic trouble code (DTC) is no longer stored in the control module.

Do you wish to continue initializing the power seat module, right (PSR)?

Yes - Initializing seat module, right (PSR)

No - DONE

-------------------------------------------------

Initializing seat module, right (PSR)

Do you wish to continue initializing the power seat module, left (PSL)?

Yes - Initializing seat module, left (PSL)

No - DONE

-------------------------------------------------