Stuck In the Active Position

Stuck in the active position

Replacing a component
A condition of the fault tracing is that the Diagnostic Trouble Code (DTC) is not generated because the control button has been held in for too long.
If the malfunction is intermittent, it means that the malfunction has been registered at an earlier time but the malfunction no longer remains. Intermittent faults can occur for a number of different reasons. The fault is evaluated depending on how it occurs.
If the fault is permanent, replace the control module.
Remedy as necessary.

Other information:
- Control module front seat Service and Repair





Continue - Verification

-------------------------------------------------

Verification

Hint: After carrying out the repair check that the symptom has been remedied.








- Ignition off.
- Reinstall the connectors, components etc.
- Ignition on.
Check that seat operation functions. Move the seat manually in all directions.

Can the seat be operated?

Yes - FAULT FOUND

No - Fault-tracing information

-------------------------------------------------

Fault-tracing information

FAULT-TRACING FAILED - DONE

Attempt New Test - Replacing a component

-------------------------------------------------