Configuration Fault

Configuration fault

Checking software
In connection with reading the vehicle configuration, the Phone module (PHM) has registered that a parameter in the vehicle configuration contains an unspecified value.
Remedy the fault by loading new software into the Central Electronic Module (CEM).

Continue - Verification

-------------------------------------------------

Verification




Verification




In order that the diagnostic trouble code (DTC) test can be rerun, the Phone module (PHM) must be restarted. Do this by:
- Remove the key from the ignition switch.
- Wait 30 seconds.
- Ignition switch position II.
Check the carphone by making a call.
Read diagnostic trouble codes by clicking the VCT2000 symbol.
Check that the current DTC has disappeared or changed status from permanent to intermittent fault.





Are the diagnostic trouble code (DTCs) still stored?

Yes - No Fault Found

No - FAULT FOUND

------------------------

No Fault Found - Information

-------------------------------------------------

Information

Attempt New Test - Checking software

-------------------------------------------------