Internal Fault

Internal fault

Checking the function
The LEDs should flash three times whenever the Blind Spot Indication System (BLIS) is activated.
Check the function of the LEDs by starting the engine.

Did the LED flash three times?

Yes - Fault-tracing information

No - Replacing a component

-------------------------------------------------

Replacing a component
The control module has registered an internal fault in the camera module.
Replace the Left/right camera modules (LCM/RCM).
Remedy as necessary.

Other information
- Rear view mirror external Rear View Mirror External





Continue - Verification

-------------------------------------------------

Verification

Hint: After carrying out the repair, check that the fault has been remedied.








- Ignition off.
- Reinstall the connectors, components etc.
- Ignition on.

Did the LED flash three times?

Yes - FAULT FOUND

No - Information

-------------------------------------------------

Information

Attempt New Test - Replacing a component

-------------------------------------------------

Fault-tracing information
The Driver door module (DDM)/Passenger door module (PDM) has previously registered a fault but the fault no longer occurs. The diagnostic trouble code (DTC) was probably caused by an intermittent fault. If the diagnostic trouble code (DTC) does not recur no further corrective action is required. The fault is evaluated depending on how it occurs.

Do you want to exit fault-tracing?

Yes - DONE

No - Replacing a component

-------------------------------------------------