Stuck In the Active Position

Stuck in the active position

Replacing the component
A condition of fault tracing is that the diagnostic trouble code (DTC) is not stored because the button for the power window mechanism has been held in for too long.
If the fault is intermittent, it has been registered previously but is no longer present. Intermittent faults can occur for a number of different reasons. The fault is evaluated depending on how it occurs.
If the fault is permanent, replace the control panel for the power window mechanism.
Remedy as necessary.

Other information:

Continue - Verification

-------------------------------------------------

Verification




Verification power window mechanism

Verification

Hint: After carrying out the repair, check that the fault has been remedied.








- Ignition off
- Reinstall the connectors, components etc.
- Ignition on.
Check that the power window mechanisms can be operated.

Does the control for the power window mechanism operate?

Yes - VERIFIED

No - VERIFICATION FAILED

------------------------

VERIFIED - FAULT FOUND

VERIFICATION FAILED - Fault-tracing information

-------------------------------------------------

Fault-tracing information

Attempt New Test - Replacing the component

-------------------------------------------------