Configuration Fault

Configuration fault

Control module programming








- Ignition off.
If the diagnostic trouble code is intermittent:
Select Continue at the bottom.
If the diagnostic trouble code is permanent:
Reprogram the parking assistance module (PAM).

Other information
- Program the parking assistance module (PAM) following the service information in VIDA.

Continue - Verification

-------------------------------------------------

Verification




Verification

Hint: After carrying out the repair check that the fault has been remedied.




- Ignition off. Wait at least 10 seconds.
- Reinstall the connectors, components etc.
- Ignition on Wait at least 10 seconds.
- Read off the diagnostic trouble codes (DTCs) by clicking on the VCT2000 symbol.
If the fault is intermittent, the fault has been remedied.





Is the fault intermittent?

Yes - VERIFIED

No - VERIFICATION FAILED

------------------------

VERIFIED - FAULT FOUND

VERIFICATION FAILED - Fault tracing information

-------------------------------------------------

Fault tracing information




Information

Fault-tracing information
The fault should have been detected and remedied. As this is not the case fault-tracing has failed.
Exit fault-tracing for this diagnostic trouble code (DTC) or make another attempt.

Do you want to exit fault-tracing?

Yes - Exit fault-tracing

No - Attempt New Test

------------------------

FAULT-TRACING FAILED - No Fault Found

Attempt New Test - Control module programming

-------------------------------------------------