Activated Too Long

Activated too long

Checking switches




- Ignition on.
Check the function of the right front outer lock button by clicking on the VCT2000 symbol.
The value for the switch should be Activated when the button is pressed in.









Is the function OK?

Yes - Fault-tracing information

No - Checking the wiring

-------------------------------------------------

Fault-tracing information
The keyless vehicle module (KVM) has previously registered a fault but the fault no longer exists. The diagnostic trouble code (DTC) was probably caused by an intermittent fault. If the fault persists, fault-tracing according to this diagnostic trouble code (DTC) must be carried out despite no fault symptoms being found. The fault is evaluated depending on how it occurs.

Continue - No Fault Found

-------------------------------------------------

Checking the wiring




- Ignition off.
Check the cable between the keyless vehicle module (KVM) and the right front outer lock button. Check for an open-circuit. Check for a short-circuit to ground.
Check the ground lead between the door handle and the ground terminal. Check for an open-circuit. Check for a short-circuit to ground.
Check the ground terminal. Check for loose connections and oxidation
Remedy as necessary.

Other information
- Connecting the breakout box Connecting the Breakout Box, Keyless Vehicle Module (KVM)
- Left-hand drive cars (LHD): Passenger door module (PDM) Passenger Door Module (PDM)
- Right-hand drive cars (RHD): Driver door module (DDM) Driver Door Module (DDM)
- Checking wiring and terminals Checking Wiring and Terminals





Was a fault detected?

Yes - Verification

No - Replacing the component

-------------------------------------------------

Replacing the component
If no other fault is discovered, the door handle should be replaced.

Other information
- Handle outer door front Service and Repair

Continue - Verification

-------------------------------------------------

Verification




Verification

Hint: After carrying out the repair, check that the fault has been remedied.








- Ignition off
- Reinstall the connectors, components etc.
- Ignition on.
Check the function of the lock button in the right front outer door handle by clicking on the VCT2000 symbol. Then press the lock button in.
The value for the lock button should be Activated when the button is pressed in.





Is the function OK?

Yes - VERIFIED

No - VERIFICATION FAILED

------------------------

VERIFICATION FAILED - Fault-tracing information

VERIFIED - FAULT FOUND

-------------------------------------------------

Fault-tracing information

Attempt New Test - Checking switches

-------------------------------------------------