Signal Too High

Signal too high

Checking the wiring








- Ignition off
- Disconnect the connector to the Integrated Audio Module (IAM).
Check the connections with regard to contact resistance, play and oxidation.
Check the antenna cable between the Integrated Audio Module (IAM) and the left-hand, rear speaker with regard to short circuit to voltage.
Measure between:
- Integrated Audio Module (IAM) #A6 and speaker #1.
- Integrated Audio Module (IAM) #A13 and speaker #2.
Remedy as necessary.

Other information
- Signal specification Signal Specification, Integrated Audio Module (IAM)
- Location of components Component Location, Integrated Audio Module (IAM)
- Rear Quarter Panel Speaker Rear Quarter Panel Speaker
- Checking wiring and terminals Checking Wiring and Terminals





Continue - Verification

-------------------------------------------------

Verification




Verification

Hint: After carrying out the repair, check that the fault has been remedied.








- Ignition off
- Reinstall the connectors, components etc.
- Ignition on
Check that the sound is heard from the speakers by testing the CD player.

Are the speakers working?

Yes - VERIFIED

No - VERIFICATION FAILED

------------------------

VERIFIED - FAULT FOUND

VERIFICATION FAILED - Fault-tracing information

-------------------------------------------------

Fault-tracing information

Attempt New Test - Checking the wiring

-------------------------------------------------