Signal Too High

Signal too high

Checking the status




- Ignition off
- Start the engine
- Read off the status of the diagnostic trouble code (DTC).

Note! If diagnostic trouble code (DTC) EPS-0030 is stored simultaneously with diagnostic trouble code (DTC) EPS-0041, diagnostic trouble code (DTC) EPS-0030 must be remedied first.





Continue - Fault-tracing information

-------------------------------------------------

Fault-tracing information
This diagnostic trouble code (DTC) may for example be stored when:
- High outside temperature or engine compartment temperature combined with "hard driving".
- Mechanical or hydraulic fault in the power steering system (example: steering gear, hoses or pipes blocked).
If the fault is intermittent it means that it has been registered previously but is no longer present. Intermittent faults can occur due to a number of different reasons. The fault is evaluated depending on how it occurs.
Check the above and remedy as necessary. Replace the electrical power steering module (EPS) if the diagnostic trouble code (DTC) subsequently recurs with a permanent status and no fault can be found (as above).

Other information
- Power steering module (PSC), B5254T7 Service and Repair.

Location Of Components:

Continue - Fault-tracing information

-------------------------------------------------

Fault-tracing information




Information

Fault-tracing information
In case of this defect, troubleshooting is not followed by verification.
The information can be displayed again or the fault-tracing for this fault can be interrupted.

Do you want to view the information again?

Yes - Attempt New Test

No - FAULT FOUND

------------------------

Attempt New Test - Checking the status

FAULT FOUND - DONE

-------------------------------------------------