Fault-Tracing Information

Fault-tracing

Checking the diagnostic trouble codes (DTCs)
Check whether the diagnostic codes for clutch pedal sensor (9110, 911B, 911C or 911D) are stored in the engine control module (ECM).
If the diagnostic trouble code is stored, it indicates a fault in the clutch pedal sensor. This, in turn, could cause generation of the diagnostic trouble code. If so, perform all troubleshooting according to these diagnostic trouble codes first.

Do you want to continue with the procedure?

Yes - Checking the component, wiring and connectors

No - No Fault Found

-------------------------------------------------

Checking the component, wiring and connectors
Check the clutch pedal switch's cable and function by measuring between Engine control module (ECM) #B13 (#C13) and ground (chassis connection).
Remedy as necessary.

Other information:
- Checking wiring and terminals Checking Wiring and Terminals
- Signal specification, B5254T7 Signal Specification, Engine Control Module (ECM)





Continue - Verification

-------------------------------------------------

Verification




Verification




- Turn off the ignition.
- Reinstall the connectors, components etc.
Check whether the fault has been remedied by switching on the ignition and attempting to start the engine. Release the ignition key/start knob from position III as soon as the starter motor has started to crank.
The autostart function should drive the starter motor until the engine starts.

Has the fault been remedied?

Yes - FAULT FOUND

No - VERIFICATION FAILED

------------------------

VERIFICATION FAILED - Fault-tracing information

-------------------------------------------------

Fault-tracing information

Attempt New Test - Checking the diagnostic trouble codes (DTCs)

-------------------------------------------------