Signal Missing

Signal missing

Checking the component and wiring
Check the fuse for the circuit.
Check the air conditioning (A/C) relay connector. Check for contact resistance and oxidation.
Check the signal cable between engine control module (ECM) terminal #B10 (#C10) and air conditioning (A/C) relay terminal #2. Check for an open-circuit.
Check the power cable between the fuse and air conditioning (A/C) relay terminal #1. Check for an open-circuit.
Remedy as necessary.

Other information
- Connecting the breakout box, B5254T7 Connecting the Breakout Box, Engine Control Module (ECM)
- Signal specification, B5254T7 Signal Specification
- For further information about the fuses and relays, see the Wiring Diagram.
- Checking wiring and terminals Checking Wiring and Terminals









Continue - Verification

-------------------------------------------------

Verification




Verification

Hint: After carrying out the repair, check that the fault has been remedied.








- Ignition off
- Reinstall the connectors, components etc.
- Ignition on.
Activate the air conditioning (A/C) relay.
A "clicking sound" should be heard from the air conditioning (A/C) relay and the air conditioning (A/C) compressor when the relay is activated.





Is the function OK?

Yes - VERIFIED

No - VERIFICATION FAILED

------------------------

VERIFICATION FAILED - Fault-tracing information

VERIFIED - FAULT FOUND

-------------------------------------------------

Fault-tracing information




Information

Fault-tracing information
The fault should have been detected and remedied. As this is not the case fault-tracing has failed.
Exit fault-tracing for this diagnostic trouble code (DTC) or make another attempt.

Do you want to exit fault-tracing?

Yes - Exit fault-tracing

No - Attempt New Test

------------------------

Attempt New Test - Checking the component and wiring

-------------------------------------------------