Fault-Tracing Information

Faulty signal

Checking the component and wiring
Check the connector for the air conditioning (A/C) pressure sensor. Check for contact resistance and oxidation.
Check that the air conditioning (A/C) system has sufficient refrigerant. Check that there is no leakage.

Hint: The diagnostic trouble code (DTC) can also be caused by a damaged air conditioning (A/C) pressure sensor.

Remedy as necessary.

Other information
- Connecting the breakout box, B5254T7 Connecting the Breakout Box, Engine Control Module (ECM)
- Signal specification, B5254T7 Signal Specification
- Location of components, engine compartment, B5254T7 Locations
- Checking wiring and terminals Checking Wiring and Terminals













Continue - Verification

-------------------------------------------------

Verification




Verification

Hint: After carrying out the repair, check that the fault has been remedied.








- Ignition off
- Reinstall the connectors, components etc.
- Start the engine
- Read off the air conditioning (A/C) pressure
- A/C on
- Blower fan on.
Check that the pressure increases in the air conditioning (A/C) system when the air conditioning (A/C) compressor engages. Also check that cold air blows out of the blower when at the coolest setting.





Is the function OK?

Yes - VERIFIED

No - VERIFICATION FAILED

------------------------

VERIFICATION FAILED - Fault-tracing information

VERIFIED - FAULT FOUND

-------------------------------------------------

Fault-tracing information




Information

Fault-tracing information
The fault should have been detected and remedied. As this is not the case fault-tracing has failed.
Exit fault-tracing for this diagnostic trouble code (DTC) or make another attempt.

Do you want to exit fault-tracing?

Yes - Exit fault-tracing

No - Attempt New Test

------------------------

Attempt New Test - Checking the component and wiring

-------------------------------------------------