Signal Missing

Signal missing

Checking the component and wiring
Check the fuse for the circuit.
Check the resistance of the evaporative emission system (EVAP) valve.
Check the evaporative emission system (EVAP) valve connector. Check for contact resistance and oxidation.
Check the signal cable between engine control module (ECM) terminal #A50 (#A50) and evaporative emission system (EVAP) valve terminal #2. Check for an open-circuit.
Check the power supply cable between system relay and evaporative emission system (EVAP) valve terminal #1. Check for an open-circuit.
Remedy as necessary.

Other information
- Connecting the breakout box, B5254T7 Connecting the Breakout Box, Engine Control Module (ECM)
- Signal specification, B5254T7 Signal Specification
- Location of components, engine compartment, B5254T7 Locations
- Checking wiring and terminals Checking Wiring and Terminals













Continue - Verification

-------------------------------------------------

Verification




Verification

Hint: After carrying out the repair, check that the fault has been remedied.








- Ignition off
- Reinstall the connectors, components etc.
- Ignition on
- Activate the evaporative emission system (EVAP) valve.
A click should be heard when the evaporative emission system (EVAP) valve is activated.









Is the function OK?

Yes - VERIFIED

No - VERIFICATION FAILED

------------------------

VERIFICATION FAILED - Fault-tracing information

VERIFIED - FAULT FOUND

-------------------------------------------------

Fault-tracing information




Information

Fault-tracing information
The fault should have been detected and remedied. As this is not the case fault-tracing has failed.
Exit fault-tracing for this diagnostic trouble code (DTC) or make another attempt.

Do you want to exit fault-tracing?

Yes - Exit fault-tracing

No - Attempt New Test

------------------------

Attempt New Test - Checking the component and wiring

-------------------------------------------------