Internal Fault

Internal fault

Initiation
- Ignition on.
The control module has registered an internal fault.
The window position must be initialized.
Move the window to its upper limit position using manual control.
Run an initialization by clicking the VCT2000 symbol.





Continue - Verification

-------------------------------------------------

Verification




Verifying initialization

Verification

Hint: After carrying out the repair, check that the fault has been remedied.








- Ignition off
- Reinstall the connectors, components etc.
- Ignition on.
Check that the automatic operation of the power window mechanisms works.

Does the automatic operation of the power window mechanisms function?

Yes - VERIFIED

No - VERIFICATION FAILED

------------------------

VERIFIED - FAULT FOUND

VERIFICATION FAILED - Fault-tracing information

-------------------------------------------------

Fault-tracing information




Information

Fault-tracing information
The fault should have been detected and remedied. As this is not the case fault-tracing has failed.
Exit fault-tracing for this diagnostic trouble code (DTC) or make another attempt.

Do you want to exit fault-tracing?

Yes - Exit fault-tracing

No - Attempt New Test

------------------------

Attempt New Test - Initiation

-------------------------------------------------