Stuck In the Active Position

Stuck in the active position

Replacing the component
A condition of fault tracing is that the diagnostic trouble code (DTC) is not stored because the button has been activated for a long time.
If the fault is intermittent, it has been registered previously but is no longer present. Intermittent faults can occur for a number of different reasons. The fault is evaluated depending on how it occurs.
If the fault is permanent, replace the control panel.
Remedy as necessary.

Other information:
- To replace the control panel see Rotary switch, front door window regulator Service and Repair.





Continue - Verification

-------------------------------------------------

Verification




Verification door mirror control

Verification

Hint: After carrying out the repair, check that the fault has been remedied.








- Ignition off
- Reinstall the connectors, components etc.
- Ignition on.
Check that the door mirrors can be operated.

Do the controls for the power door mirror function?

Yes - VERIFIED

No - VERIFICATION FAILED

------------------------

VERIFIED - FAULT FOUND

VERIFICATION FAILED - Fault-tracing information

-------------------------------------------------

Fault-tracing information




Information

Fault-tracing information
The fault should have been detected and remedied. As this is not the case fault-tracing has failed.
Exit fault-tracing for this diagnostic trouble code (DTC) or make another attempt.

Do you want to exit fault-tracing?

Yes - Exit fault-tracing

No - Attempt New Test

------------------------

Attempt New Test - Replacing the component

-------------------------------------------------