No Communication

No communication

Checking the component and wiring
The diagnostic trouble code (DTC) indicates that communication between the central electronic module (CEM) and the wiper motor module (WMM), rain sensor module (RSM) (accessory), is not functioning. This may be due to a fault in the cable between the control modules or a defective communication device in one or both of the control modules.
Check the cable between the central electronic module (CEM) and the wiper motor module (WMM). Check for an open-circuit. Check for a short-circuit to ground.
Take readings between:
- Central electronic module (CEM) connector terminal #G3 (#3) and wiper motor module (WMM) terminal #1.
Also check that the fuse for the windshield wipers is intact. Replace the fuse if necessary.
Check the cable between the central electronic module (CEM) and the rain sensor module (RSM). Check for an open-circuit. Check for a short-circuit to ground.
Take readings between:
- Central electronic module (CEM) connector terminal #H23 (#37) and rain sensor module (RSM) terminal #3.
Also check that the fuse for the rain sensor is intact. Replace the fuse if necessary.

Other information
- Connecting the breakout box Connecting the Breakout Box, Central Electronic Module (CEM)
- Location of components Component Location, Central Electronic Module (CEM)
- Checking wiring and terminals Checking Wiring and Terminals













Was a fault detected?

Yes - Verification

No - Replacing the control module

-------------------------------------------------

Replacing the control module
Try replacing the wiper motor module (WMM).

Other information

Continue - Verification

-------------------------------------------------

Verification




Verification

Hint: After carrying out the repair, check that the fault has been remedied.








- Ignition off
- Reinstall the connectors, components etc.
- Ignition on.
Activate the windshield wipers in the intermittent wiping position.
Activate the windshield wipers in the low speed position.
Activate the windshield wipers in the high speed position.
Check the function. See: Rain sensor, check Testing and Inspection
Check that the function is OK.

Is the function OK?

Yes - VERIFIED

No - VERIFICATION FAILED

------------------------

VERIFIED - FAULT FOUND

VERIFICATION FAILED - Fault-tracing information

-------------------------------------------------

Fault-tracing information

FAULT-TRACING FAILED - No Fault Found

Attempt New Test - Checking the component and wiring

-------------------------------------------------