Signal Missing

Signal missing

Checking the component and wiring
The diagnostic trouble code (DTC) indicates that the communication between the left-hand gas discharge lamp module (GDL) and the central electronic module (CEM) is interrupted. This may be due to a fault in the cable between the control modules or a defective communication device in one or both of the control modules.
Check the cable between the central electronic module (CEM) and the left-hand gas discharge lamp module (GDL). Check for an open-circuit. Check for a short-circuit to ground.
Take readings between:
- Central electronic module (CEM) connector terminal #G26 (#26) and left-hand gas discharge lamp module (GDL) terminal #A12.
Also check that the fuse for the headlamp is intact. Replace the fuse if necessary.

Other information
- Connecting the breakout box Connecting the Breakout Box, Central Electronic Module (CEM)
- Location of components Component Location, Central Electronic Module (CEM)
- Control module relay box passenger compartment Service and Repair
- Checking wiring and terminals Checking Wiring and Terminals









Was a fault detected?

Yes - Verification

No - Replacing the control module

-------------------------------------------------

Replacing the control module
Try replacing the gas discharge lamp module (GDL), left.

Other information

Continue - Verification

-------------------------------------------------

Verification




Verification

Hint: After carrying out the repair, check that the fault has been remedied.








- Ignition off
- Reinstall the connectors, components etc.
- Ignition on
- Light switch in position 2.
Switch between high and low beam.
Check that the function is OK.

Is the function OK?

Yes - VERIFIED

No - VERIFICATION FAILED

------------------------

VERIFIED - FAULT FOUND

VERIFICATION FAILED - Fault-tracing information

-------------------------------------------------

Fault-tracing information




Information

Fault-tracing information
The fault should have been detected and remedied. As this is not the case fault-tracing has failed.
Exit fault-tracing for this diagnostic trouble code (DTC) or make another attempt.

Do you want to exit fault-tracing?

Yes - Exit fault-tracing

No - Attempt New Test

------------------------

FAULT-TRACING FAILED - No Fault Found

Attempt New Test - Checking the component and wiring

-------------------------------------------------