Signal Too High

Signal too high

Checking the status




- Ignition on.
Activate headlamp wash / wipe.
Check if the fault is permanent or intermittent.
The headlamp wash / wipe relay clicks when it is activated.
The fault is permanent if the headlamp wash / wipe does not activate.
If the headlamp wash / wipe is activated, this is an indication that the fault was present previously but that it is not active at the moment, i.e. the fault is intermittent.





Continue - Checking the component and wiring

-------------------------------------------------

Checking the component and wiring
- Ignition off.
Check that relay 2/182 is correctly installed.
Also check the relay terminal, in particular 2/182 terminal #2. Check for a short-circuit to supply voltage.
Remedy as necessary.

Other information
- Connecting the breakout box Connecting the Breakout Box, Central Electronic Module (CEM)
- Cable, battery to generator, B5254T7 Service and Repair
- Checking wiring and terminals Checking Wiring and Terminals









Continue - Verification

-------------------------------------------------

Verification




Verification

Hint: After carrying out the repair, check that the fault has been remedied.








- Ignition off
- Reinstall the connectors, components etc.
- Ignition on.
Click the VCT2000 symbol to activate and deactivate the relay.
A click should be heard from the relay.
Check that the function is OK.





Is the function OK?

Yes - VERIFIED

No - VERIFICATION FAILED

------------------------

VERIFIED - FAULT FOUND

VERIFICATION FAILED - Fault-tracing information

-------------------------------------------------

Fault-tracing information

Attempt New Test - Checking the component and wiring

-------------------------------------------------