Signal Too Low

Signal too low

Checking the status




- Ignition on.
Activate the stop lamp.
Check if the fault is permanent or intermittent.
The stop lamp must light on activation.
The fault is permanent if the stop lamp does not activate.
If the stop lamp is activated, this is an indication that the fault was present previously but that it is not active at the moment, i.e. the fault is intermittent.





Continue - Checking the component and wiring

-------------------------------------------------

Checking the component and wiring
5-doors
Check the voltage on the right-hand stop lamp connector terminal #2 to the output on the central electronic module (CEM). The voltage must be approximately 12 V when the stop lamp is activated.
Check the control signal cable. Check for a short-circuit to ground.
Take readings between:
- Central electronic module (CEM) terminal #C4 (#4) and right-hand stop lamp connector terminal #1.
Remedy as necessary.
4-doors
Check the voltage on the right-hand stop lamp connector terminal #3 to the output on the central electronic module (CEM). The voltage must be approximately 12 V when the stop lamp is activated.
Check the control signal cable. Check for a short-circuit to ground.
Take readings between:
- Central electronic module (CEM) terminal #C4 (#4) and right-hand stop lamp connector terminal #3.
Remedy as necessary.

Other information
- Connecting the breakout box Connecting the Breakout Box, Central Electronic Module (CEM)
- Checking wiring and terminals Checking Wiring and Terminals













Continue - Verification

-------------------------------------------------

Verification




Verification

Hint: After carrying out the repair, check that the fault has been remedied.








- Ignition off
- Reinstall the connectors, components etc.
- Ignition on.
Click the VCT2000 symbol to activate and deactivate the right-hand stop lamp.
Check that the function is OK.





Is the function OK?

Yes - VERIFIED

No - VERIFICATION FAILED

------------------------

VERIFIED - FAULT FOUND

VERIFICATION FAILED - Fault-tracing information

-------------------------------------------------

Fault-tracing information

Attempt New Test - Checking the component and wiring

-------------------------------------------------