Faulty Signal

Faulty signal

Checking the wiring








- Ignition off
- Disconnect the sun roof module (SRM) connector.
Check the power cable. Check for an open-circuit. Check for a short-circuit to ground.
Take readings between:
- Central electronic module (CEM) terminal #H20 (#34) and sun roof module (SRM) terminal #6.
Remedy as necessary.

Other information
- Connecting the breakout box Connecting the Breakout Box, Central Electronic Module (CEM)
- Location of components Component Location, Central Electronic Module (CEM)
- Rotary switch, sun roof Service and Repair
- Checking wiring and terminals Checking Wiring and Terminals









Continue - Verification

-------------------------------------------------

Verification




Verification

Hint: After carrying out the repair, check that the fault has been remedied.








- Ignition off
- Reinstall the connectors, components etc.
- Ignition on.
Use the sun roof switch to activate the automatic closing function when the vehicle is maintaining a speed above 90 km/h.
The sun roof must close automatically without being affected by the airflow.
Check that the function is OK.

Is the function OK?

Yes - VERIFIED

No - VERIFICATION FAILED

------------------------

VERIFIED - FAULT FOUND

VERIFICATION FAILED - Fault-tracing information

-------------------------------------------------

Fault-tracing information

Attempt New Test - Checking the wiring

-------------------------------------------------