Signal Too High

Signal too high

Checking the wiring








- Ignition off.
Check central electronic module (CEM) connector F and the seat belt buckle connector. Check for contact resistance. Check for oxidation. Check for damage. Check for loose connections. Also check the intermediate connector.
Check the signal cable. Check for a short-circuit to supply voltage.
Take readings between:
- Central electronic module (CEM) terminal #F2 (#2) and right rear seat belt buckle, connector terminal #2.
Remedy as necessary.

Other information
- Connecting the breakout box Connecting the Breakout Box, Central Electronic Module (CEM)
- Location of components Component Location, Central Electronic Module (CEM)
- Checking wiring and terminals Checking Wiring and Terminals













Continue - Verification

-------------------------------------------------

Verification




Verification

Hint: After carrying out the repair, check that the fault has been remedied.








- Ignition off
- Reinstall the connectors, components etc.
- Ignition on.
Activate reading off the status. Click the VCT2000 symbol.
Activate and deactivate the function.
Check that the function is OK.





Is the function OK?

Yes - VERIFIED

No - VERIFICATION FAILED

------------------------

VERIFIED - FAULT FOUND

VERIFICATION FAILED - Fault-tracing information

-------------------------------------------------

Fault-tracing information

Attempt New Test - Checking the wiring

-------------------------------------------------