Diagnostic Trouble Code (DTC) Information

Diagnostic trouble code (DTC) information CEM-3F92

Condition
The central electronic module (CEM) checks the signal from the accelerator pedal (AP) position sensor.
The diagnostic trouble code (DTC) is stored if the control module registers that the signal is too high or that there is no signal.
The diagnostic trouble code (DTC) can be diagnosed with the ignition in positions I or II.

Substitute value
- None.

Possible source
- Short-circuit to supply voltage in the signal cable
- Open-circuit in the signal cable
- Damaged accelerator pedal (AP) position sensor.

Fault symptom[s]
- Engine feels sluggish
- No accelerator pedal (AP) response.