Signal Too Low

Signal too low

Checking the status




- Ignition on.
Check the signal from the clutch pedal sensor.
Click on the VCT2000 symbol to read off the voltage level.
Slowly depress and release the clutch. Note the change in the signal level.
The voltage level in the clutch pedal sensor must be between 0.15 and 4.75 volts.

Hint: If the signal from the clutch pedal sensor indicates <0.15 volts, there is either an open-circuit in the cable or the clutch pedal sensor is defective.





Does the value change?

Yes - Verification

No - Checking the component and wiring

-------------------------------------------------

Checking the component and wiring
Check the clutch pedal sensor resistance.
Check the signal cable between central electronic module (CEM) terminal #G21 (#21) and clutch pedal sensor connector terminal #3. Check for a short-circuit to ground.
Check the signal cable between central electronic module (CEM) terminal #G23 (#23) and clutch pedal sensor connector terminal #2. Check for a short-circuit to ground.
Check the signal cable between central electronic module (CEM) terminal #G12 (#12) and clutch pedal sensor connector terminal #1. Check for a short-circuit to ground.
Try replacing the clutch pedal sensor if no fault is found in the wiring.
Remedy as necessary.

Other information
- Connecting the breakout box Connecting the Breakout Box, Central Electronic Module (CEM)
- Checking wiring and terminals Checking Wiring and Terminals









Continue - Verification

-------------------------------------------------

Verification




Verification

Hint: After carrying out the repair, check that the fault has been remedied.








- Ignition off
- Reinstall the connectors, components etc.
- Ignition on.
Read off the clutch pedal sensor. Click the VCT2000 symbol.
Check that the value is between 0.15 and 4.75 volts.





Is the value OK?

Yes - VERIFIED

No - VERIFICATION FAILED

------------------------

VERIFIED - FAULT FOUND

VERIFICATION FAILED - Fault-tracing information

-------------------------------------------------

Fault-tracing information

Attempt New Test - Checking the component and wiring

-------------------------------------------------