Signal Too High

Signal too high

Checking the wiring and connectors




- Ignition off
- Check the connector pin for the horn's relay in Central electronic module (CEM) #G18 (#18) for short-circuiting to voltage. Also check the cable between Central electronic module (CEM) #G18 (#18) and horn relay (2/17) in the front fuse box. Check for a short-circuit to supply voltage. For more information, see wiring diagram and signal description.
- Click the VCT2000 symbol to read out relay status.
- If no problem was detected, replace the relay 2/17.

Other information
- Connecting the breakout box Connecting the Breakout Box, Central Electronic Module (CEM)
- Location of components Component Location, Central Electronic Module (CEM)
- Checking wiring and terminals Checking Wiring and Terminals





Continue - Verification

-------------------------------------------------

Info

Attempt New Test - Checking the wiring and connectors

FAULT-TRACING FAILED - No Fault Found

-------------------------------------------------

Verification





Hint: After carrying out the repair check that the fault has been remedied.

- Ignition off.
- Reinstall the connectors, components etc.
- Ignition on.
- Check that the horn is working.

Is the function OK?

Yes - FAULT FOUND

No - Info

-------------------------------------------------