Internal Fault

Internal fault

Replacing the component
The Climate control module (CCM) has registered an internal fault in the rear tunnel console switch.
If the fault is intermittent, it has been registered previously but is no longer present. Intermittent faults can be caused by interference at start up of the tunnel console switch or may be a different type of fault which occurs on different occasions. The fault is evaluated depending on how it occurs. If the fault returns, replace the rear tunnel console switch.
In the event of a permanent fault, replace the rear tunnel console switch.
- Switch tunnel compartment Switch Tunnel Compartment
Remedy as necessary.





Continue - Verification

-------------------------------------------------

Verification




Verification

Hint: After carrying out the repair, check that the fault has been remedied.








- Ignition off
- Reinstall the connectors, components etc.
- Ignition on.
Read off the diagnostic trouble codes (DTCs) by clicking on the VCT2000 symbol. Check that the relevant diagnostic trouble code (DTC) has switched status from permanent to intermittent fault.





Does the status change?

Yes - VERIFIED

No - VERIFICATION FAILED

------------------------

VERIFICATION FAILED - Information

VERIFIED - FAULT FOUND

-------------------------------------------------

Information

Attempt New Test - Replacing the component

-------------------------------------------------