Diagnostic Trouble Code (DTC) Information

Diagnostic trouble code (DTC) information BPM-B100

Condition
The control module compares its configuration ID with the signal configuration transmitted on the control area network (CAN) by the central electronic module (CEM).
The diagnostic trouble code (DTC) is stored if the control module detects that:
- The vehicle configuration has not been obtained.
The control module's test for the diagnostic trouble code (DTC) starts in the event of:
- Ignition on and battery voltage between 9 and 16 V.
- Ignition on for at least 60 seconds.





Substitute value
- None.

Possible source
- Interference in communication between Bluetooth phone module (BPM) and Central electronic module (CEM).
- Incorrect configuration ID (the control module is not intended for this vehicle, for example it is a used control module with different software/hardware).

Fault symptom[s]
- Bluetooth Telephone: No Functionality