Internal Memory Fault

Internal memory fault

Checking the diagnostic trouble codes (DTCs)








- Ignition off
- Check the connector on the brake control module (BCM). Check for contact resistance. Check for oxidation
- Reinstall the components, connectors, etc.
- Ignition on
- Wait approximately 60 seconds
- Read off the status of the diagnostic trouble code (DTC).
Remedy as necessary.

Other information
- Connecting the breakout box, B5254T7 Connecting the Breakout Box, Brake Control Module (BCM)
- Anti-lock Brake System Module (ABS) Anti-Lock Brake System Module (ABS)
- Checking wiring and terminals Checking Wiring and Terminals





Was the status of the diagnostic trouble code (DTC) permanent?

Yes - FAULT FOUND

No - Fault-tracing information

-------------------------------------------------

Fault-tracing information




Information

Fault-tracing information
If the fault is intermittent, do not verify fault-tracing if the fault does not recur.
It is possible to view the information again, or leave fault-tracing for this diagnostic trouble code (DTC).

Do you want to view the information again?

Yes - Attempt New Test

No - FAULT FOUND

------------------------

Attempt New Test - Checking the diagnostic trouble codes (DTCs)

-------------------------------------------------