Diagnostic Trouble Code (DTC) Information

Diagnostic trouble code (DTC) information

Condition

Note! The diagnostic trouble code (DTC) applies only to cars with dynamic stability and traction control (DSTC).

The brake pressure sensor is inside the hydraulic modulator and transmits signals to the brake control module (BCM) about the pressure in the brake system. Diagnostic trouble code (DTC) BCM-0130/BCM-0131/BCM-0132/BCM-0133 is stored, depending on the type of signal fault that has occurred, if the control module registers an incorrect signal from the brake pressure sensor.
The diagnostic trouble code (DTC) can be diagnosed when the ignition is switched on.

Substitute value
- Traction Control is blocked
- Stability Control is blocked
- Active yaw control is blocked.

Hint: Brake system, abbreviations Brake System, Abbreviations

Possible source
- The pressure sensor in the hydraulic modulator is not functioning
- Internal fault in the brake control module (BCM).

Fault symptom[s]
- Warning lights and chimes/Antispin/antiskid (DSA, TRACS, STC, DSTC) indication/no indication
- Traction control does not function
- The stability control system does not function.