Diagnostic Trouble Code (DTC) Information

Diagnostic trouble code (DTC) information BCM-0119

Condition





Note! The diagnostic trouble code (DTC) applies only to cars with dynamic stability and traction control (DSTC).

The diagnostic trouble code (DTC) is stored if the brake control module (BCM) registers that the supply voltage to the body sensor cluster stability sensor (BSC) is below 6 V ±0.5 V.
The diagnostic trouble code (DTC) can be diagnosed at speeds above 20 km/h.

Substitute value
- Traction Control is blocked
- Stability Control is blocked
- Active yaw control is blocked.

Hint: Brake system, abbreviations Brake System, Abbreviations

Possible source
- Contact resistance in the terminals for the body sensor cluster stability sensor (BSC)
- Short-circuit to ground in the power supply for the body sensor cluster stability sensor (BSC)
- Open-circuit in the power supply or ground lead for the body sensor cluster stability sensor (BSC)
- Internal fault in the body sensor cluster stability sensor (BSC)

Note! This diagnostic trouble code (DTC) is not due to an internal hardware fault in the Brake control module (BCM) and must not be remedied by replacing the control module.

Fault symptom[s]
- The information lamp is lit
- Traction control does not function
- The stability control system does not function.