Diagnostic Trouble Code (DTC) Information

Diagnostic trouble code (DTC) information BCM-0114

Condition





Note! The diagnostic trouble code (DTC) applies only to cars with dynamic stability and traction control (DSTC).

The diagnostic trouble code (DTC) is stored if the brake control module (BCM) registers that the signal from the body sensor cluster stability sensor (BSC) is absent.
The diagnostic trouble code (DTC) can be diagnosed when the ignition is switched on.

Substitute value
- Traction Control is blocked
- Stability Control is blocked
- Active yaw control is blocked.

Hint: Brake system, abbreviations Brake System, Abbreviations

Possible source
- Contact resistance in the terminals
- Open-circuit in the wiring between the brake control module (BCM) and the body sensor cluster stability sensor (BSC)
- Body sensor cluster stability sensor (BSC) not connected
- Internal fault in the body sensor cluster stability sensor (BSC).

Note! This diagnostic trouble code (DTC) is not due to an internal hardware fault in the Brake control module (BCM) and must not be remedied by replacing the control module.

Fault symptom[s]
- The information lamp is lit
- Traction control does not function
- The stability control system does not function.