Sensor Not Calibrated

Sensor not calibrated

Fault-tracing information

Hint: The diagnostic trouble code (DTC) may be stored when downloading software, in which case it only needs to be erased.

Note! Only erase the diagnostic trouble code (DTC) if it was stored when downloading software.




- Ignition on.
Erase diagnostic trouble codes (DTCs).





Continue - Calibration

-------------------------------------------------

Calibration




Calibrate the brake control module (BCM). See Vehicle communication, Calibration. Press "Pause". Save a bookmark so that the fault-tracing can be resumed after calibration.

Continue - Reading off the status of the diagnostic trouble code (DTC)

-------------------------------------------------

Reading off the status of the diagnostic trouble code (DTC)




- Ignition on
- Wait approximately 60 seconds
- Read off diagnostic trouble codes (DTCs).
If the status of the diagnostic trouble code (DTC) has changed from permanent to intermittent the fault is no longer active.
Remedy as necessary.

Other information
- Accelerometer and yaw angle sensor Service and Repair





Is the status of the diagnostic trouble code (DTC) intermittent?

Yes - FAULT FOUND

No - Verification

-------------------------------------------------

Verification




Verification

Hint: After carrying out the repair, check that the fault has been remedied.








- Ignition off
- Reconnect the connectors, components, etc.
- Test drive the car according to: Test Drive Form (DSTC (dynamic stability and traction control) /brake control module), description Test Drive Form (DSTC (Dynamic Stability and Traction Control) /Brake Control Module), Description
- Ignition on.
Read off the status of the diagnostic trouble code (DTC).





Is the status of the diagnostic trouble code (DTC) intermittent?

Yes - VERIFIED

No - VERIFICATION FAILED

------------------------

VERIFICATION FAILED - Fault-tracing information

VERIFIED - FAULT FOUND

-------------------------------------------------

Fault-tracing information




Information

Fault-tracing information
The fault should have been detected and remedied. As this is not the case fault-tracing has failed.
Exit fault-tracing for this diagnostic trouble code (DTC) or make another attempt.

Do you want to exit fault-tracing?

Yes - Exit fault-tracing

No - Attempt New Test

------------------------

Attempt New Test - Fault-tracing information

-------------------------------------------------