Diagnostic Trouble Code (DTC) Information

Diagnostic trouble code (DTC) information BCM-0112

Condition





Note! The diagnostic trouble code (DTC) applies only to cars with dynamic stability and traction control (DSTC).

A check sum is stored in the brake control module (BCM) when the sensors included in the stability function (active yaw control) are calibrated. At each start up, the control module checks the stored check sum against a calculated check sum.
The diagnostic trouble code (DTC) is stored if the check sums do not correspond.
The diagnostic trouble code (DTC) can be diagnosed when the ignition is switched on.

Substitute value
- Traction Control is blocked
- Stability Control is blocked
- Active yaw control is blocked.

Hint: Brake system, abbreviations Brake System, Abbreviations

Possible source
- The diagnostic trouble code (DTC) can be stored after the offset values for each sensor in the body sensor cluster stability sensor (BSC) have been reset
- The brake control module (BCM) is damaged.

Fault symptom[s]
- The information lamp is lit
- Traction control does not function
- The stability control system does not function.