Diagnostic Trouble Code (DTC) Information

Diagnostic trouble code (DTC) information BCM-0111

Condition





Note! The diagnostic trouble code (DTC) applies only to cars with dynamic stability and traction control (DSTC).

At each new ignition cycle, the brake control module (BCM) compares a value for the steering wheel angle from the steering wheel angle sensor with a calculated value. The diagnostic trouble code (DTC) is stored if the brake control module (BCM) registers that the deviation is too great.
The diagnostic trouble code (DTC) can be diagnosed at speeds above 10 km/h and when the steering wheel has been turned 10 degrees in either direction.

Substitute value
- Traction Control is blocked
- Stability Control is blocked
- Active yaw control is blocked.

Hint: Brake system, abbreviations Brake System, Abbreviations

Possible source
- Incorrect wheel alignment
- Incorrect steering wheel alignment
- Damaged steering wheel angle sensor.

Note! This diagnostic trouble code (DTC) is not due to an internal hardware fault in the Brake control module (BCM) and must not be remedied by replacing the control module.

Fault symptom[s]
- The information lamp is lit
- Traction control does not function
- The stability control system does not function.