AYC Stability Control Active For Too Long

AYC stability control active for too long

Checking and adjusting the front wheel alignment

Warning! If there are any other diagnostic trouble codes (DTCs) in the brake control module (BCM), these must be fault traced first.

The diagnostic trouble code (DTC) indicates that the stability function has been active for too long. Check and adjust the front wheel alignment.

Other information
- Wheel angles, check Service and Repair

Continue - Erasing diagnostic trouble codes (DTCs)

-------------------------------------------------

Erasing diagnostic trouble codes (DTCs)




- Ignition on
- Erase the diagnostic trouble code (DTC) from the brake control module (BCM).





Continue - Reading off diagnostic trouble codes (DTCs)

-------------------------------------------------

Reading off diagnostic trouble codes (DTCs)




- Ignition off
- Wait approximately 15 seconds
- Ignition on
- Read off diagnostic trouble codes (DTCs).





Is diagnostic trouble code (DTC) BCM-0111 stored?

Yes - Fault-tracing information

No - FAULT FOUND

-------------------------------------------------





Information

Fault-tracing information
The fault should be diagnosed and remedied. Since this is not the case the fault-tracing process has failed.
Complete the fault-tracing for those fault or try again.

Do you want to terminate fault-tracing at this time?

Yes - Exit fault-tracing

No - Attempt New Test

------------------------

Attempt New Test - Checking and adjusting the front wheel alignment

-------------------------------------------------