Faulty Configuration
Faulty configuration
Erasing diagnostic trouble codes (DTCs)
- Ignition on
- Erase diagnostic trouble codes (DTCs)
- Switch off the ignition.
Continue - Reading off diagnostic trouble codes (DTCs)
-------------------------------------------------
Reading off diagnostic trouble codes (DTCs)
- Ignition off
- Ignition on
- Wait at least 15 seconds
- Read off diagnostic trouble codes (DTCs).
Was diagnostic trouble code (DTC) BCM-0076 stored?
Yes - Resetting and configuring the brake control module (BCM)
No - DONE
-------------------------------------------------
Resetting and configuring the brake control module (BCM)
- Ignition on
- Reset the configuration.
Continue - Erasing diagnostic trouble codes (DTCs)
-------------------------------------------------
Erasing diagnostic trouble codes (DTCs)
Hint: In certain cases, diagnostic trouble codes (DTCs) may be stored when resetting the configuration in the brake control module (BCM). Any diagnostic trouble codes (DTCs) must therefore be erased.
- Ignition off
- Ignition on
- Wait at least 15 seconds
- Erase diagnostic trouble codes (DTCs).
Continue - Reading off diagnostic trouble codes (DTCs)
-------------------------------------------------
Reading off diagnostic trouble codes (DTCs)
- Ignition off
- Ignition on
- Wait at least 15 seconds
- Read off diagnostic trouble codes (DTCs).
Was diagnostic trouble code (DTC) BCM-0076 stored?
Yes - Resetting and configuring the brake control module (BCM)
No - Fault-tracing information
-------------------------------------------------
Fault-tracing information
Information
Fault-tracing information
In case of this defect, troubleshooting is not followed by verification.
The information can be displayed again or the fault-tracing for this fault can be interrupted.
Do you want to view the information again?
Yes - Attempt New Test
No - FAULT FOUND
------------------------
Attempt New Test - Erasing diagnostic trouble codes (DTCs)
-------------------------------------------------