Fault-Tracing Information

Fault-tracing TCM-P092813

Check the function solenoid for the shift lock




- Ignition on
- Gear selector in position P.
- Try to move the gear selector lever without depressing the brake pedal. It should not be possible to move the gear selector lever.
- Try to move the gear selector lever with the brake pedal depressed. It should now be possible to move the gear selector lever.
If the gear selector lever function is not OK it indicates that the fault is permanent.
If the gear selector lever function is OK it means that the fault was present previously but is not active now. There is an intermittent fault.

Continue - Checking the wiring and component

-------------------------------------------------

Checking the wiring and component




Check the cable between the connector on the transmission control module (TCM) #13 (#A43), gear selector module (GSM) terminal #3 and the shift lock solenoid connector terminal #2. Check for an open circuit.
Remedy as necessary.
Check the resistance of the solenoid between terminals #1 and #2 on the connector. If the resistance is not correct, replace the solenoid.

Other information
- Solenoid shift lock, replace, B8444S, TF-80SC AWD, B6324S5, TF-80SC AWD, B6324S5, TF-80SC Service and Repair
- For resistance values: Component specifications, B8444S, TF-80SC AWD [1][2]Control Module, A/T
- Checking wiring and terminals Checking Wiring And Terminals





Continue - Verification

-------------------------------------------------

Verification




Verification

Hint: After carrying out the repair, check that the fault has been remedied.








- Ignition off
- Reinstall the components, reconnect the connectors etc.
- Ignition on
- Gear selector in position P.
- Try to move the gear selector lever without depressing the brake pedal. It should not be possible to move the gear selector lever.
- Try to move the gear selector lever with the brake pedal depressed. It should now be possible to move the gear selector lever.

Is the function OK?

Yes - VERIFIED

No - VERIFICATION FAILED

------------------------

VERIFICATION FAILED - Fault-tracing information

VERIFIED - FAULT FOUND

-------------------------------------------------

Fault-tracing information

Attempt New Test - Check the function solenoid for the shift lock

-------------------------------------------------